Instructions / Assembly

FOAM Rubber Bottom WEATHER

Seal For WOOD Garage Doors

1) Unplug your garage door opener and

disconnect it from the garage door.

2) Secure the garage door in the full open position

by placing a C-clamp or vice grip above the top

roller to keep the door from moving

(Figure 1).

3) Remove the old seal from the garage door.

4) Use ﬂat-head nails in 6-inch increments to

attach the new seal to the bottom of the

wood garage door (Figure 2).

5) Trim the seal end ﬂush with the door edge.

6) Remove the clamps, close the door and

reconnect it to the garage door opener.

TOOLS NEEDED

C-Clamp, Flat Head Nails, & Hammer

INSTALLATION INSTRUCTIONS

Figure 1

Figure 2

Garage

Door

Outside

of Garage

Nail

Weather

Seal

WARNING!

INSTALLATION BY A TRAINED DOOR SYSTEMS TECHNICIAN IS HIGLY RECOMMENDED TO

PREVENT SERIOUS INJURY OR DEATH.

Springs bottom brackets, red colored fasteners, cables, and supports are under extreme tension and can cause

serious injury or death. You should never remove the bottom roller carrier. If your garage door is connected to an

automatic opener, be sure to disengage the opener before starti

ng installation. Do not place ﬁngers or hands into

door section joint. Use lift handles or gripping points when operating door manually. Never use other objects to

prop open the door. If complications during installation occur, contact a trained door systems technician for service.

C-clamp

FOAM BOTTOM WEATHER

SEAL INSTRUCTIONS

DURALIFTHARDWARE.COM

PAGE 1
FOAM Rubber Bottom WEATHER FOAM BOTTOM WEATHER Seal For WOOD Garage Doors SEAL INSTRUCTIONS INSTALLATION INSTRUCTIONS 1) Unplug your garage door opener and disconnect it from the garage door. 2) Secure the garage door in the full open position by placing a C-clamp or vice grip above the top roller to keep the door from moving (Figure 1). 3) Remove the old seal from the garage door. 4) Use flat-head nails in 6-inch increments to attach the new seal to the bottom of the wood garage door (Figure 2).