Replacement Part List

3
6' Picnic Table
TABLE TOP ASSEMBLY
Lay out five 72" table top rails (part 1) as shown above with pilot holes facing up. Table top rails have two
holes in the center of each rail, seat rails do not. Set two 25½" table brackets (part 5) over pilot holes at each
end of table top rail, leaving ⅛" gap between rails. Using twenty ¾" screws per bracket, fasten each bracket to
table top rails.
Apply glue to inner edges of
⅞ x 1½" end cap (from hardware bag) and press on each end of 27" center brace
(part 7). Set center brace over pilot holes in center of table top. Using ten 1½" screws, fasten center brace to
table top.
Apply glue to inside edges of 28" table top end cap (part 9). Press end cap onto ends of table top (DO NOT
slide from end). Take care that end cap is flush with ends of table and use a file to round off any sharp edges.