Replacement Part List

6' Picnic Table
5
CROSS BRACE / LEG ASSEMBLY
Lay
out two 30¼" legs (part 4) on an angle with pre-drilled holes for attaching table top, nearest each other at
top. Lay one 59½" cross brace (part 3) across legs; adjusting legs so bolt holes line up.
Using four 3½" botls, eight washers and four nuts, fasten cross brace to legs. (Do not over tighten as this will
crush the vinyl) Bolt heads will face outside of the table.
Apply glue to inside edges of 5½" cross brace end cap (part 12). Press end cap onto ends of cross brace (DO
NOT slide from end). Take care that end cap is flush with ends and use a file to round off any sharp edges.
Apply glue to inside edges of 6⅛" seat end cap (part 11). Press end cap onto ends of seat (DO NOT slide from
end).