Installation Guide

Camelot Arbor

Lay out one right post (part 2). Starting at

bottom, insert one bottom cross rail (part

4) and nine center cross rails (part 3).

Slide one left post (part 1) over

corresponding cross rails.

Insert one 63” vertical rail (part 5) through

center hole of cross rails.

Insert two 55” vertical rails (part 6)

through remaining holes in cross rails.

PAGE 1
Lay out one right post (part 2). Starting at bottom, insert one bottom cross rail (part 4) and nine center cross rails (part 3). 2 Slide one left post (part 1) over corresponding cross rails. 3 Insert one 63” vertical rail (part 5) through center hole of cross rails. 4 Insert two 55” vertical rails (part 6) through remaining holes in cross rails.
PAGE 2
5 Using ¾” screws, screw together arbor panel. Be sure that all parts are fully inserted into posts before securing. 6 Using included super glue, glue arrowhead caps onto vertical rails. REPEAT steps 1-6 for second arbor panel 7 Using super glue, glue ⅞ x 1½" end caps one each end of eight 41" arbor top cross rails (part 8).
PAGE 3
8 9 10 Using 1¼” screws, screw six of eight arbor top cross rails with caps to arbor top panels (part 7). Do not attach end arbor top cross rails at this time Insert one end of each 18" corner brace (part 9) into routed hole on bottom of arbor top rails. Insert ends of arbor top rails through holes at top of each post of arbor panels, inserting free ends of corner braces into other routed holes in posts.
PAGE 4
11 12 Using 1¼” screws, screw remaining two arbor top cross rails with caps to arbor top panels. Using super glue tube, glue four arbor top end caps (part 10) onto ends of arbor top rails. Glue four 2" sq. post caps onto post tops.