Installation Instructions

Dura-Trel, Inc. ~ PO Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020

#11159 COTTAGE TRELLIS

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED:

Drill w/ #2 Phillip Bit or

Phillips Screwdriver

Super or Crazy Glue

Hammer or Mallet

TRELLIS ASSEMBLY

(Refer to Drawing)

On clean flat surface, lay the two 2 x 2 x 65" posts with screw pilot holes facing up and routed holes for

7/8 x 1 ½ x 29 ¾" cross rails facing each other. Insert one of the 7/8 x 1 ½ x 29 ¾" top/bottom rails into

the bottom routed holes in post, then insert the center rails.

Slide the 1 x 1 x 58" vertical rails through the routed holes of the cross rails and insert the last top/bottom

cross rail into the top of the posts guiding the 1 x 1's into the top rail. Firmly press the posts together so

that all cross rails are completely inserted in the posts.

Fasten the posts and cross rails with the ¾" screws and snap the screw caps over the screw heads.

Apply household glue to inside edges of 2 x 2 post caps and set on top of posts. Trellis is now ready for

installation (See Ground Anchor Hardware Bag).

If you encounter missing or defective parts, please contact manufacturer direct at toll free

# below.

PAGE 1
#11159 COTTAGE TRELLIS ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: Drill w/ #2 Phillip Bit or Phillips Screwdriver Super or Crazy Glue Hammer or Mallet TRELLIS ASSEMBLY (Refer to Drawing) On clean flat surface, lay the two 2 x 2 x 65" posts with screw pilot holes facing up and routed holes for 7/8 x 1 ½ x 29 ¾" cross rails facing each other. Insert one of the 7/8 x 1 ½ x 29 ¾" top/bottom rails into the bottom routed holes in post, then insert the center rails.
PAGE 2
PAGE 3
2” sq. post trellis ground anchor Assembly & installation Instructions Parts List: Description 16” L-channel Ground Anchor 1” Self-tapping White-head Screws Qty 2 4 Option 1 (soft ground) Slide one 16” steel L-channel ground anchor into bottom of each post. Slide ground anchor up to bottom cross rail. Using two 1” selftapping white-head screws per post, screw post to ground anchor (figure 1). When fastening, use one screw per side where ground anchor meets post.