Instructions / Assembly

ManualsBrandsDura-Trel ManualsStorage & OrganizationKingston 8 ft. 9 in. x 8 ft. 9 in. White Vinyl Pergola

Model#

11300

Assembly Instructions

Part # Description Box#

1 4" sq. x 93" Post 1

2 1½ x 5½ x 106" Bottom Support Rail 2

3 1½ x 5½ x 106" Upper Support Rail 2

4 ⅞ x 1½ x 106" Top Cross Rail 2

1½" Upper Support Bracket 3

6 4" sq. New England Post Cap 3

7 6⅛" Top End Cap 3

8 30" Steel Ground Anchor (U-shaped) 1

9 Hardware Bag

(includes:)

⅞ x 1½" End Cap

2" Painted Screw

1¼" Painted Screw

¾" Painted Screw

#8 - 1" Painted Self Tapping Screw

PLEASE READ THROUGH BEFORE BEGINNING ASSEMBLY. Super Glue Tube

IMPORTANT: Check boxes for Contents Listed

Check inside of parts as some parts are packaged

inside of others

In the event of missing, damaged or defective parts

please call our customer service dept. at 1-877-258-6020

When assembling components, place on a clean, flat

non-abrasive surface to avoid scratches

…

Battery or Electric Drill with #2 phillips bit

… Tape Measure

…

Hammer or Rubber Mallet (recommended)

…

Shovel or Post Hole Digger (recommended)

150 Birch Road

P.O. Box 122

Sheboygan Falls, WI 53085

www.dura-trel.com

sales@dura-trel.com

Tools Required

1-877-258-6020

General Information

Qty

Kingston Pergola

Summary of content (7 pages)

PAGE 1
Kingston Pergola Model# 11300 Part # General Information PLEASE READ THROUGH BEFORE BEGINNING ASSEMBLY. IMPORTANT: Check boxes for Contents Listed Assembly Instructions Description Box# Qty 1 4" sq. x 93" Post 1 4 2 1½ x 5½ x 106" Bottom Support Rail 2 2 3 1½ x 5½ x 106" Upper Support Rail 2 5 4 ⅞ x 1½ x 106" Top Cross Rail 2 7 5 1½" Upper Support Bracket 3 6 6 4" sq.
PAGE 2
Warranty Statement 20 Year Guarantee Please call manufacturer direct with questions concerning missing or defective parts at Toll Free: 877-258-6020. Dura-trel, Inc. products are warranted to be free from manufacturing defects resulting in delaminating, peeling, flaking, corroding, cracking, crazing, or extreme amounts of fading or bleaching causing the PVC to change to its natural color for a period of 20 years from the date of purchase.
PAGE 3
Lay out one lower support rail(part 2). 1 [Lower support has six pilot holes drilled in top edge] Using ¾" painted screws, fasten three upper support brackets (part 5) to lower support. Insert ends of lower support rail through bottom routed holes of two posts (part 1). 2 Do not screw together at this time. REPEAT steps 1 and 2 using remaining lower support, upper support brackets and posts. Instruction Text Insert ends of two upper support rails (part 3) through top routed holes of posts.
PAGE 4
Lay two top cross rails (part 4) onto upper supports. To set width of pergola, line up outer most holes of top rails with outer most pilot holes of upper supports. Using 1¼” painted screws, fasten top rails to upper supports. 5 Using 2” painted screws, screw together all posts and supports. 6 Slide three remaining upper support rails (part 3) through upper support brackets, underneath top rails.
PAGE 5
7 Using 1¼” painted screws, fasten top cross rails to upper supports. [This will center remaining upper supports] 8 Using 1¼” painted screws, fasten remaining top cross rails (part 4) to upper supports. 9 Using included Super Glue, glue post caps (part 6) to top of posts. Glue support end caps (part 7) to ends of upper and lower supports. Glue ⅞ x 1½" end caps to ends of top cross rails.
PAGE 6
PERGOLA INSTALLATION 10 Option 1 Slide one 30” steel ground anchor (part 8) into bottom of each post. Slide ground anchor about 12 inches into post, leaving 18 inches for in-ground. Using 1” painted self-tapping screws fasten post to ground anchor. Dig holes approximately 18 inches deep. Set pergola in holes and level. Back fill with soil removed from holes. For permanent installation fill with cement. Option 2 Pound ground anchors into ground according to dimensions.
PAGE 7
11300 1 2 3 4 5 6 Kingston Pergola 4" sq. x 93" PER Post 1½ x 5½ x 106" KPER Top Rail 1½ x 5½ x 106" KPER Bot Supp ⅞ x 1½ x 106" PER Top Cross 30" Steel Grnd Anch (U-shaped) Hardware Bag 4" sq. New England Cap #1039 ⅞ x 1½" End Cap 2" Painted Screw 1¼" Painted Screw ¾" Painted Screw #8 - 1" Self Tapping White He Super Glue Tube 4.00 5.00 2.00 7.00 4.00 1.00 4.00 14.00 24.00 35.00 24.00 8.00 1.