Safety data sheet

Date : 03/08/2015 Page 3/9
Revision : N°4 (01/04/2015)
SAFETY DATA SHEET (REGULATION (EC) n° 1907/2006 - REACH)
Version : N°3 (03/08/2015)
In the event of a fire, the following may be formed :
- carbon monoxide (CO)
- carbon dioxide (CO2)
In a fire or if heated, a pressure increase will occur and the container may burst. Bursting aerosol containers may be propelled from a fire at
high speed. Promptly isolate the scene by removing all persons from the vicinity of the incident if there is a fire. No action shall be taken
involving any personal risk or without suitable training.
Move containers from fire area if this can be done without risk. Use water spray to keep fire-exposed containers cool.
5.3. Advice for firefighters
Fire-fighting personnel are to be equipped with autonomous insulating breathing apparatus.
If possible, stop the product stream. Spray from a protected position till the containers are cool. If possible, take the aerosols outside. Keep
public on a distance.
SECTION 6 : ACCIDENTAL RELEASE MEASURES
6.1. Personal precautions, protective equipment and emergency procedures
Consult the safety measures listed under headings 7 and 8.
For non first aid worker
Because of the organic solvents contained in the mixture, eliminate sources of ignition and ventilate the area.
For first aid worker
First aid workers will be equipped with suitable personal protective equipment (See section 8).
6.2. Environmental precautions
Evacuate area. Stop flow. Eliminate all sources of ignition.
6.3. Methods and material for containment and cleaning up
Not applicable.
6.4. Reference to other sections
No data available.
SECTION 7 : HANDLING AND STORAGE
Requirements relating to storage premises apply to all facilities where the mixture is handled.
7.1. Precautions for safe handling
Always wash hands after handling.
Ensure that there is adequate ventilation, especially in confined areas.
Fire prevention :
Handle in well-ventilated areas.
Vapours are heavier than air. They can spread along the ground and form mixtures that are explosive with air.
Prevent the formation of flammable or explosive concentrations in air and avoid vapor concentrations higher than the occupational exposure
limits.
Do not spray on a naked flame or any incandescent material.
Do not pierce or burn, even after use.
Use the mixture in premises free of naked flames or other sources of ignition and ensure that electrical equipment is suitably protected.
Keep packages tightly closed and away from sources of heat, sparks and naked flames.
Do not use tools which may produce sparks. Do not smoke.
Prevent access by unauthorised personnel.
Recommended equipment and procedures :
For personal protection, see section 8.
Observe precautions stated on label and also industrial safety regulations.
Do not breathe in aerosols.
Packages which have been opened must be reclosed carefully and stored in an upright position.
Prohibited equipment and procedures :
No smoking, eating or drinking in areas where the mixture is used.
7.2. Conditions for safe storage, including any incompatibilities
No data available.
Storage
Keep out of reach of children.
Keep away from all sources of ignition - do not smoke.
Keep well away from all sources of ignition, heat and direct sunlight.
- Made under licence of European Label System® MSDS software from InfoDyne - http://www.infodyne.fr -
5796 POWERCLEAN STANDARD