Instructions / Assembly

Installation & Assembly Instructions
Please contact our Customer Service Division with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 1 INDB707
Read all instructions completely before installing. Should you have any questions about your
installation, please call Customer Service at 440-248-5480
1. Review Carton Contents: (2 Boxes Make Up This Kit)
4 Pcs. Polyethylene Pegboard 24" X 48"X 3/16” Thick
88 Pcs. Assortment DuraHook™ Locking Pegboard Hooks
8 Pcs. BinClips™ for hanging Plastic Bins
8 Pcs. Hanging Plastic Bins
120 Pcs. Lock Screws for hooks (short screws packaged separately)
32 Pcs. #12-2" long mounting screws
32 Pcs. #12 plastic wall anchors
32 Pcs. Metal wall mounts/spacers
2. Wall Mounting Instructions: Polyethylene pegboards can be mounted to walls in separate locations,
side by side horizontally or above one another vertically.
A) Determine the location or locations where you want to mount your new storage system.
B) Determine if you want to mount boards (a.) side by side horizontally (b.) above or below one
another, or (c.) in different locations from each other.
C) Using one sheet of the Polyethylene Pegboard (DuraBoard™) determine the location and
height you wish to mount your storage system.
D) (Using diagram 1-1) Hold one sheet of Polyethylene Pegboard flat against the wall surface,
use level to make sure board is level and square.
E) (Using diagram 1-1) While still holding pegboard flat against wall level and using a pencil,
make a circular trace inside of all (8) hole locations using diagram 1-1. (If planning to mount
boards in totally separate locations go on to step (H)
F) If you’re planning to mount the second pegboard directly to the side or above or below the
first: Hold the first pegboard flat against the wall while making sure all 8 traced holes are
still aligned with appropriate holes in pegboard. Using a pencil, trace the outer edge of the
board you’re planning to mount the second board against.
G) If mounting side by side or above or below one another: use the second board in your kit,
align outer edge with the pencil mark created in step (F). Do not cover up pencil mark with
board. Mark hole locations as called out in step (E).
H) Using an electric drill with 5/16" drill bit, drill hole locations marked in step (E) and (G).
Should any hole location fall in line with a wood wall stud, it will not be necessary to pre-
drill.
I) Gently insert plastic wall anchors into holes pre-drilled in step (H.) (You will not need to
install plastic wall anchors where wall studs are located or when installing on solid wood
surfaces. Wall anchors will be required for all concrete walls.
J) Using your first pegboard sheet Insert all eight (8) #12- 2" wood screws through the
pegboard holes specified in diagram 1-2.
DB-4BK Kit - (4) 24x48 DuraBoard/96 Hook/8 Bin