Operation Manual

- 19 -
MAINTENANCE
CLEANING CD
If the CD skips or will not play, the disc may need cleaning.
Before playing, wipe the disc from the centre out with a cleaning cloth.
After playing, store the disc in its case.
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by
lightly wiping with a soft cloth.
IMPORTANT NOTE
Before transporting the unit, take out all discs from the CD tray.
TROUBLESHOOTING GUIDE
CAUSE (AND REMEDY)
• Press the VOLUME UP button.
• The headphones are connected. Disconnect them.
• Reset the unit by pressing the Power/Standby switch.
• Suddenly OFF when playing, the TIMER OFF function are
activted. Press the STOP button until the 'TIMER OFF' indicator
show on the display.
• Check the speaker connections of the inoperative channel.
• Check the speaker cord connection and speaker location.
• Check that the speakers are connected the correct way
round.
• The TV or VCR is too close to the stereo system. Separate the
stereo system from the TV or VCR.
• Adjust the antenna wire.
• Set the MODE switch to FM MONO, the FM STEREO light will
go out.
• Press the FUNCTION button to select CD mode and press the
DISC SKIP button. The door will close.
• The disc's are not placed correctly.
• Dirty disc.
• The disc is inserted upside down.
• The player is in the pause mode.
• Moisture condensation
• CD disc is dirty or scratched.
SYMPTOM
GENERAL
No sound.
No sound from one channel or unbalanced left and right
volume.
Reversed left and right sound.
Lack of bass sound or apparently imprecise physical
location of musical instruments.
Severe hum or noise.
RADIO RECEPTION
The FM STEREO indicator flashes.
Severe hum or noise.
The stereo FM program cannot be received in stereo.
CD PLAYER OPERATION
CD door does not close due to power off or other functions
are selected without closing it first.
Play does not start.
Distorted playback or sound loss during CD playback.
Power consumption 150W
Power requirements AC ~ 120V 60Hz
Specifications and external appearance are subject to change without advance notice due to continuous
product improvement.
SPECIFICATIONS
Printed in China
811-277591-240
2775SW-eng1.pmd 10/29/2004, 3:06 PM19