Install Manual

4 PCS and Battery Cabinet Wall-Mounting Instructions

1. Mount the wall bracket to the wall. Use the available slot pattern to

mount to a load-bearing structure rated for the weight of the final

system. The slots accommodate a M8 (5/16”) bolt diameter.

IMPORTANT! Wall-stud mounting: A minimum of three wall

studs spanned within the width of the mounting bracket are

required. A minimum of two mounting bolts are required per

stud (top/bottom).

2. (not shown) Remove the battery cabinet from the packaging, and

stand the cabinet upright. Remove the front cover.

3. Mount the two leveling brackets to the back side of the cabinet.

Each side of the cabinet must have a rubber washer in direct

contact with the cabinet wall.

4. Lift the battery cabinet onto the wall mount bracket, aligning the

wall hooks at the rear of the cabinet with the slots on the load-

bearing face of the bracket.

5. Slide the battery cabinet towards the right end of the bracket to

allow for clearance for the PCS cabinet.

6. From the rear side of the cabinet, adjust the outer wingnuts on the

levelling brackets until the cabinet is vertically plumb (level) to the

wall.

14kWh

LFP

5kW