Install Manual

11
5.3 Preparing battery modules for
installation
The PCS cabinet is not shown in the following steps.
CAUTION! Ensure the battery module power
switches are in the OFF position throughout the
following procedure.
Note: Observe the rotation of the modules on
the lower and upper racks. The lower rack is
rotated such that the chassis ground terminal
is at the bottom of the module, while the upper rack
chassis ground terminal is at the top.
1. (not shown) Remove a battery from its
packaging. Remove the rackmount ears, if
supplied with the battery.
2. Attach two adhesive-backed module pads
(included in the battery module hardware kit)
to the battery modules as shown. For the lower
rack of modules, the pads are installed on the
top face of the battery. For the upper rack, the
pads are installed on the bottom face of the
battery.
upper rack
lower
rack