Troubleshooting guide

Using Duracell® Powerpack for the First Time
11
Using Duracell® Powerpack for the First
Time
Recharging with the AC Charger
Recharging with the AC charger is a true “plug-in-and-
forget” charging method. We recommend leaving the AC
charger connected when the Duracell® Powerpack is not in
use.
To recharge with the AC charger:
1. Disconnect any 12 V DC appliances from the DC power
outlets.
2. Disconnect any AC products from the Duracell®
Powerpack and turn the AC Power
ON/OFF switch to OFF.
3. Insert the AC charger cable end into the AC charger input
socket located under the red jump-starting clamp (see
figure on page 6).
4. Plug the AC charger into a standard AC wall outlet.
Important: Prior to operating your AC appliance or 12 V DC
appliance, ensure that the battery of the Duracell® Powerpack is
fully charged. If the battery has been fully discharged, recharging
with the AC charger may take up to 24 hours.
Note
: The Duracell® Powerpack battery level LEDs are only
accurate when the Duracell® Powerpack has been disconnected
from all appliances and all charging sources for fifteen minutes.
CAUTION
Do not operate AC or DC appliances with the Duracell®
Powerpack while the Duracell® Powerpack is being recharged
with the AC charger.
The AC charger may be permanently damaged if AC appliances or
12 V DC appliances are operated while the AC charger is
connected.
Duracell_PP_300_PlusEP.book Page 11 Wednesday, June 13, 2007 4:02 PM