Troubleshooting guide

Troubleshooting Reference
41
The engine
being jump-
started will not
start.
Duracell® Powerpack
battery is not fully
charged.
The engine condition is
poor.
The engine start capacity
exceeds the Duracell®
Powerpack jump-start
capability.
Recharge the Duracell®
Powerpack battery.
Have the engine serviced.
Use a higher power Duracell®
Powerpack.
The jump-start
clamps
measure zero
volts.
Jump-start power switch is
OFF.
Duracell® Powerpack
battery needs to be
recharged.
Turn the jump-start power
switch
ON.
The
compressor
runs, but won’t
inflate.
The valve connector may
not be securely placed on
the valve stem.
The item being inflated
may have a leak.
Make sure the valve connector is
securely placed on the valve
stem before closing the thumb
latch.
Make sure the item being
inflated doesn’t have a leak.
Check the compressor hose for
any breaks or leaks.
The
compressor
runs slowly.
The compressor may have
overheated from excessive
use.
Battery voltage is too low.
Turn off the compressor and let it
cool down.
Check the condition of the
internal battery. The battery may
need to be recharged or replaced.
Table 5-1 Troubleshooting reference
Problem Possible Cause Solution
Duracell_PP_300_PlusEP.book Page 41 Wednesday, June 13, 2007 4:02 PM