Use and Care Manual

modernmaven | Rigid Core
DuraDecor | P: (855) 700 - 5666 | [e-mail] | duradecor.com | revised on 02.7.23 | Page 1
Maintenance Instructions
1. Precautions
Do not perform any maintenance procedures on wall
installations for 72-hours. Remove all metal objects before
conducting maintenance and prohibit foot trac until the
oor is dry. Do not use dust mops treated with oils or
silicones, acetone, strong alkaline cleaning agents, multi-
surface cleaners, vinegar/ammonia/ citrus oil solutions,
scouring powder, strong solvents, or abrasive cleaning
pads, as these can damage the ooring. Do not wet mop
or allow cleaning solutions to puddle or pool on the surface
of the material. The application of a oor-nish is not
recommended and will change the maintenance protocol.
2. Regular Cleaning
Wipe, dust-mop or vacuum the material to remove any dirt
or grit – do not use a vacuum with a beater bar. Damp-mop
or wipe the material as often as required using a clean cloth,
a at microber mop or a spray mop or a at microber
spray mop. Use a pH neutral, lm-free and streak-free
cleaner concentrate (diluted with potable water), available
at local hardware stores. Make sure to change the cloth or
mop pad as often as required.
3. Deep Cleaning
Deep cleaning may be required when routine cleaning is
not meeting expectations. Dust-mop or vacuum the oor
to remove dirt or grit. Wet mop the entire oor using a
suitable neutral pH cleaning solution. Allow the solution to
dwell for ~ 5-10 minutes. Scrub the oor using a medium
nylon broom or brush and remove the soiled solution using
a wet vacuum. Rinse with clean water and allow it to dry
before allowing foot trac.