polishedpro | 2.
polishedpro | 2.
polishedpro | 2.0mm LVT Recommended Tool List • Knee Pads • Safety Glasses • Cut-Resistant Safety Gloves • Dust Mask • HEPA-Filtered Vacuum • Oscillating Multi-Tool or Hand Saw (for door jambs) • Chalk Line • Three-Section 100 lb. Floor Roller • Appropriate Notch Trowel • Tape Measure • Utility Knife with Blades • Pencil • Speed Square • 6-foot and 1-foot Straight Edge or Level DuraDecor | P: (855) 700 - 5666 | customercare@duradecor.com | duradecor.com | revised on 02.7.
polishedpro | 2.0mm LVT Installation Instructions 1. Substrate Preparation General Substrate Guidelines Ensure the substrate is clean, dry, flat, sound and suitably prepared according to these instructions prior to installation, as manufacturer is not responsible for problems related to substrates that have not been properly prepared.
polishedpro | 2.0mm LVT Installation Instructions vinyl or linoleum, as well as existing hard surface flooring substrates, such as terrazzo, porcelain or ceramic tile. Ensure existing flooring is a single layer and is clean, dry, sound, solid and well adhered. All loose material must be removed and repaired or replaced. All grout lines and wide seams greater than 1/4-in.
polishedpro | 2.0mm LVT Installation Instructions Adhesive Application Only apply as much adhesive as can be covered within the working-time, typically to only one side of the starting line at a time. Apply the adhesive slowly and evenly to the substrate at the appropriate angle using the specified trowel notch. Avoid skips, puddles or sharp trowel turns. Allow the specified open time for the adhesive, depending on the porosity of the substrate and the site conditions.
