Use and Care Manual

polishedpro | 2.0mm LVT

Maintenance Instructions

1. Precautions

Remove all metal objects before conducting maintenance

and use caution tape and/or “Wet Floor” signs to prohibit

foot trac until the oor is dry. Do not use hydrocarbons,

harsh disinfectants, cleaning agents, dyes, acetone or

other harsh chemicals – ensure all chemicals and materials

that may come in contact with ooring surface will not

stain, mar or otherwise damage the surface. Do not use

abrasive cleaning pads, as these can damage the ooring.

The application of a oor-nish is not usually recommended

and will change the maintenance protocol. Allow area to dry

completely before allowing foot trac.

2. Regular Cleaning

Dust-mop or vacuum the oor to remove any dirt or

debris. Damp-mop the oor as often as required using a

at microber mop or a spray mop. Use a pH neutral, lm-

free and streak-free cleaner concentrate, available at home

improvement stores, and make sure to change the pad as

often as necessary. Steam cleaners with a micro-ber head

may also be used, providing the steaming head is never

stationary, as prolonged, excessive heat can damage any

vinyl oor covering.

3. Deep Cleaning

Deep cleaning may be required when routine cleaning

is not meeting expectations. Dust-mop or vacuum the

oor to remove dirt or grit. Wet mop the entire oor

using a suitable neutral pH cleaning solution. Allow the

solution to dwell for ~ 5-10 minutes. Scrub the oor

using a medium nylon broom or brush and remove the

soiled solution using a wet vacuum. Rinse with clean

water and allow it to dry before allowing foot trac.