Installation Guide

Layout: The layout is recommended to be balanced with equal sizes on the top/bottom and left/right. Measure the area, calculate and mark
your center/starting line (length direction) using a pencil and level. If the last rows are going to be less than half the width of a plank, then move
your line over by half the width of the plank.
A random pattern is recommended with ≥ 6-inches end-seam separation from the previous row. Measure and mark your starting point, one
end of your first plank (near the center of the wall).
Do not install within 4-inches (10-cm) of any radiant heat source like boiler systems with wall mounted exchangers or radiators, electric or other
types of baseboard heating systems. Ensure that open ranges and cooktops are at least 8-inches (20-cm) away and enclosed ovens, stoves,
toasters, toaster ovens, fryers, etc. are at least 2-inches (6-cm) away from the installed DuraDecor.
Electrical outlets and light switch covers should be removed after the power supply has been shut o. The DuraDecor cut to fit around them
and then have the covers replaced, covering all cut edges. All electrical work must be performed by qualified electricians.
>6"
July 2019