Full Product Manual

weekendwarrior | P&S LVT
DuraDecor | P: (855) 700 - 5666 | [e-mail] | duradecor.com | revised on 06.23.23 | Page 4
General Information
Limitations
WeekendWarrior is a peel-and-stick vinyl product that is
designed to be installed in residential indoor applications
only. This product must be installed over an approved
substrate that is properly primed with a suitable latex-based
primer - failure to do so could result in adhesion issues.
Avoid prolonged exposure to direct sunlight or other heat
sources where temperatures will exceed 90° F (32° C), as
damage or deformation may occur. Use non-rubber backed
entrance matting at all outdoor entrances, as this will
improve air quality and reduce maintenance. If required or
concerned, immediately contact the technical department at
1-(855) 700 - 5666 or [e-mail] for
assistance.
Warning
All local, state, and federal regulations must be followed;
this includes the removal of in-place asbestos (oor
covering and adhesive) and any lead-containing material.
The Occupational Safety and Health Administration (OSHA)
has exposure limits for people exposed to respirable
crystalline silica; this requirement must be followed. Do
not use solventor citrus-based adhesive removers. When
appropriate, follow the Resilient Floor Covering Institute’s
(RFCI) Recommended Work Practice for Removal of Existing
Floor Covering and Adhesive. Always wear safety glasses
and use respiratory protection or other safeguards to avoid
inhaling any dust.The label, installation, and maintenance
instructions along with the technical data sheet, limited
warranty and anyappropriateSafety Data Sheet (SDS) of
all products must be read, understood, and followed before
installation commences. If the substrate or suboor fails
for any reason, then the oor covering limited warranty is
void.
Documentation
Record and le the measured and observed site
conditions and test results, including all photographs and
corrective measures. Maintaining this documentation,
along with the original invoice and any labor receipts
throughout the warranty period, is recommended, as this
will be required in the unlikely event of a claim.
Site Conditions & Storage
The tile, adhesive and accessories must be stored in
dry indoors conditions between 40° F - 90° F (4° C - 32°
C). Do not store outside (even in containers) and do not
stack pallets. The installation area must be fully enclosed
and weather tight. Protect the adhesive and tile from
excessive temperature uctuations. Use permanent or
temporary HVAC systems to control the site condition. The
temperature must be between 60° F to 80° F (16° C to 27°
C) and constant ( ±5° F) for 48-hours before, during and
after the installation. The ambient relative humidity must
be between 35% and 65% and 10° F above dew point, with
temperatures rising – dew point calculators are available
on the Internet. Failure to ensure these conditions are met
could aect adhesion and product stability.
Flooring acclimation is not required when the Receiving
Material & Storage requirements and the Site Conditions &
Acclimation requirements are both met. If these conditions
cannot be met, installation cannot proceed until the
ambient temperature and humidity conditions are within
the acceptable range and the ooring material is within
the acceptable ambient temperature range (± 2°F) when
measured with an infrared (IR) thermometer.