Instructions / Assembly

FOR YOUR OWN SAFETY
1. Always unplug the heater when not in use. Do not pull the cord to unplug the heater.
2.Keep the air inlet and outlet free from objects: at least 3.3 ft. in front and 35 in. behind the
heater.
3. Do not locate the heater right below a socket.
4. Do not use this fan heater in the immediate surroundings of a bath, a shower or a
swimming pool.
5. Keep the fan heater clean. Do not allow any objects to enter any ventilation or exhaust
opening as this may cause electric shock or re or damage to the heater.
WARNINGS
-Do not use the appliance in the vicinity of showers, bathtubs, wash basins, swimming pools,
etc.
- Always use the heater in an upright position.
-Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger
of overheating).
-Do not place it against walls, furniture, curtains, etc.
-Replacement of the cable must be entrusted only to a technician authorized by the
manufacturer because such work requires special tools.
-The appliance must not be positioned directly underneath a socket.
-Do not use the appliance in rooms less than 43 sq. ft. area.
-Heater should not be located below a socket-outlet.
The heater is tted with a thermal overload protector which will switch off the heater in case
of accidental overheating (ex. obstruction of air intake and outlet grilles, motor turning slowly
or not at all).
To reset, disconnect the plug from the power for a few minutes, remove the cause of
overheating then plug the appliance in again.
WARNING
To avoid injury from unexpected starting or electrical shock, do not plug the power cord
into a source of power during unpacking and assembly. The cord must remain unplugged
whenever you are adjusting/assembling the heater.
If any part is missing or damaged, do not attempt to use or plug in the power cord until the
missing or damaged part is correctly replaced. To avoid electric shock, use only identical
replacement parts when servicing double-insulated tools.
E-4