Installation Guide

MODELS: DFI-5010-01, DFI-5010-02, DFI-5010-03,DFI-5010-04,DFI-5010-05,DFI-5010-06
-- POWER
-- FLAME
-- HEATER
-- TIMER
Made in China
Printed in China
© 2015,Twin-Star International,Inc.
VOLTAGE
120 VAC, 60 Hz
AMPS 12.5 Amps
WATTS 1500 Watts
PRODUCT SPECIFICATIONS
OPERATING INSTRUCTIONS
The POWER button supplies power to all the
functions of the heater. Pressing the POWER
button again the heater will be put in standby
mode. This will turn off all functions at once but
will hold the settings in the memory. By pressing
the Power button again the unit will turn on at
the same settings.
With the power on press and hold the Power
button on the control panel for 10 seconds to dis-
able or re-enable the heater function. Once
disable or re-enabled the emberbed lights will
flash multiple times.
OPERATING INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
There are 5 brightness levels that can be selected
and OFF (00) setting.
Settings F5 - F1 decrease in brightness.
For Customer Service:
www.tsicustomerservice.com
([phone]
8:30 a.m.-5:30 p.m., EST, Monday-Friday
Distributed by
Twin-Star International, Inc. Under license.
duraflame™ and the duraflame flame
logo are trademarks of Duraflame, Inc.
Twin-Star International, Inc.
Delray Beach, FL 33445
Made in China • Printed in China
MOUNTING THE LEGS
1. Align the mounting tab into the bracket and lower the leg into
place. (Fig 1)
2. Fasten the leg to the bracket using the included screws, 3 per
leg.
Note: When first running the heater there can
be an odor. This is normal, the heater has a
surface coating on the internal parts, for the
first several hours of operation the coating
reacts with the internal parts to permanently
protect them. The odor is safe; if you are
sensitive to the odor it is recommended
to run the heater in a well-ventilated area until
the odor dissipates.
Warning: This is an unvented, electric
appliance. DO NOT attempt to burn wood or
manufactured firelogs in or on this appliance
or grate.
Go to www.tsicustomerservice.com for product warranty registration
The stove contains a fan forced infrared element
heater.
The thermostat setting range is 62°F - 82°F (17°C
- 27°C) or continously ON or OFF(00).
The thermostat is adjustable by 2°F or 1°C
increments by pressing the HEATER button on the
control panel.
To change between °F and °C press and hold
the HEATER button on the control panel for 3
seconds.
The button on the remote only turns the heater
on/off to the thermostat setting selected with the
control panel.
Pressing the timer button will cycle through the
timer settings; 30 minutes, 1 Hour, 2H, 3H, 4H,
5H, 6H, 7H, 8H, 9H and off (00).
Control Panel
Remote Control
Control Panel Location
Remote Receiver
Bracket
Leg
1
2