Features of the Hipper 1.Modem design, smooth outline and blade-like fuselage. 2 Perfect in 3A flying, and can also do some 3D aerobatic maneuvers. Strong wind-resistance. strong power system & high quality servos ensure happy and stable flying experience. simply, orderly and easy to malignant equipment layout design. 5.Durable, easy to maintain and beautiful EPO material used, avoid troubles caused by unexpected and fatty flying. Specification Fuselage length: 800mm (36.4 in) Wingspan: 800mm {35.
AURA = Rd 2 Apply glue to the lower wing strut wells and install struts in position.
Apply slug to the opening at the tail and insert the horizontal stabilizer as shown. Ensure the 8.Insert rudder with installed hinges into corresponding slots on fuselage, and fix with glue. distance between ‘C' and ‘D’ are equal. {Ensure there's 1mm between rudder and fuselage.) 7.Insert assembled landing gear into corresponding location on fuselage, and secure with the plastic undercarriage tab provided. 5.
8.Secure the tail whee! to the underside of the rear fuselage as shown using (M2*8mm) screws 11 Right wing: Assemble push rod to control horn. Secure assembly to servo { ember to center and insert the rear wire into the round slot on fuselage, then use glue to fix. the servo first). Glue the servo into pocket of underside of the wing (es shown) 9.Left wing: Assemble push rod to control hom. Secure assembly to servo { ember to center the servo first).
CLIT RYG ha 15.Install rudder and elevator servo into the servo tray as shown, securing with the screws provided. 14.Connect aileron [ink rod to aileron horns on both of upper and lower wing as shown. Adjust 18.Install supplied control rod fasteners to the servo ohms, then secure control hom to the servo.
FLY 17 Install motor to the firewall using *X' mount supplied with motor and using screws provided, 19.With all mounting holes aligned secure the spinner to the medal using the (M2*8mm) as shown below. sorrows provided as Shawn below. 18.Install propeller and spinner back plate onto the motor shaft in the order shown. Make sure the mounting 20.Install your choice of ESC into the area noted below. Fix in place with Velcro. holes in the spinner line up to the holes on the spinner back and front plate.
21. Install your choice of receiver in front of the servos as shown and secure with Velcro. 23 Remove the battery hatch under the front of the nose. For flight, secure your flight battery with Velcro, moving forwards and backwards until the desired CoG is achieved. (CG shown later). 22. With electronic installation complete, close the servo bay with the hatch provided. 24. Replace battery hatch as shown.
25.Check for the comet center of gravity before flying. The CG is approximately 95mm from the leading edge of the upper wing. Control throws: * Elevator low rates’ 15mm high tales’ 3mm In either direction from neutral. {ravel, 120% up and 100% down) * flatiron “low rates’ 10mm high rates’ 15mm in either direction from neutral. * Rudder low rates’ 18mm ‘high tales’ 25mm in fisher directions From neutral.
Wing struts Accessories Motor 2212 Kvi4oo Rudder 17 Battery Hatch Servo Hatch Spinner & Back Plate Servo arm protector Water decals BJRaan4e “aE 18
