same utensil, | Specifications: Lengthen Flight weight: 1050g Wingspan :1100mm Radio system: 5CH Tx and 6CH Rx Brush less motor 2836 Out runner Kv2700 AESCHYLUS spices servo less mechanical retracts landing gear 70mm Dusted Fan LI-PO battery Safety Precautions: -This Is an electric remote controllable model plane and Is not a toy. -This D.H.100 Vampire model Is designed for Intermediate to advanced pilots. -Children younger than 12 years old must be accompanied by an adult when operating this model.
LIFER og SCE Items Included =» Compartment cover Pilot } Main wing(right) } Bs mu Man wing(left) Fuselage ’ ’ | Bae yes gue i Y line Stabilizer Parts Battery Charging: The battery must ba fully charged before you attempt fo fly this D.H.100 vampire. To charge the battery, connect the Li-Po battery to the balance charger and the charger to the universal adapter. The universal adapter in tum connects to a car battery via the two alligator clips at the end.
PUI AMPUTEE ATE = Assembly Instructions: 1.Glue the pilot into the cockpit, and then glue the canopy on. 2 Fit and install the aileron. Install the rod to the Aileron. This rad connects the versa to the Aileron.
showrooms] | 4.Fit and install the elevator. Then install the rod to the servo. Apply glue to the fuselage. Then connect the elevator control line to the servo.
EAR I A Ll 5.Apply glue to the fuselage, and then attach the main wing to the fuselage. Repeat for the other wing.
wonderment 6.Make sure the center of Gravity {CG) is as indicated in the follow diagram. Finn Operating the D.H.100 Vampire Powering Up 1. The correct power up process is to turn on the transmitter (controller) first. 2. Lower both the throttle stick (left Joystick for Mode 2) and the throttle trim tab (eft vertical trim tab on Mode 2} all the way down before powering up the D.H.100 Vampire. 3. To power on the D.H.100 Vampire, connect the battery to the ESC (electric speed controller).
= Final Adjustments: 1. Tum on the transmitter. Make sure the throttle stick and throttle tim tab are both all the way down. Canter all the other trim tabs. 2. Connect the plane's battery to the ESC (Electronic Speed Controller) underneath the plane's cockpit. When connected, you will hear three beeps to Indicate that It Is working. 3. Check that the servos In the plane are set In the neutral position. You may have to make minor adjustments to the servos or wires.