User Manual

Assembly of your Durafly Ugly Stik is now complete.

Before you move onto the final set-up of the model, we suggest

you perform a final check on all screws, bolts and components to

ensure all are secture and firmly in place.

1. With your receiver installed and all servos plugged into their corresponding channels,

connect the flight battery to the ESC to power up the model. With the model now armed,

ensure all servo’s are centered and all control surfaces are level. If not, adjust by turning

the control clevis’s by hand accordingly until the control surfaces are level as shown.

Note: For saftey reasons, it is advised that this is done with the prop removed from the

model.

SETTING UP YOUR MODEL:

Ailerons Elevator Rudder