User Manual

Assembly of your Durafly Me-163 is now complete.

Before you move onto the final set-up of the model, we suggest

you perform a quick check on all screws, bolts and components to

ensure all are secure and firmly in place.

RECEIVER AND BATTERY INSTALLATION.

1. Use the below image as a guide to install your receiver and flight battery. When

using the recommended 2200mah 3S battery, these positions should make your model

balance at the approximate CG mark covered in the next stage of this manual.

Note: If you are using a lower capacity (and therefore lighter) battery, you will have to

install this pack further forward of the point shown in order to attain the same

approximate CG position.