User Manual

1. With your receiver installed and all servos plugged into their corresponding

channels (see instructions provided by your receiver manufacturer for ‘Delta’ or

‘Elevons’ set-up procedures), connect the flight battery to the ESC to power up the

electronics. With the model now armed, ensure all servo’s are centered and the

rudder control surface is neutral as shown. If not, adjust by turning the control

clevis’s by hand accordingly.

Note: For safety reason, please remove the prop before arming your model during

the set-up stage.

SETTING UP YOUR MODEL:

2. Owing to the design of the Me-163, a small amount of up ‘reflex’ is required in the

ailerons to improve all round flight handling. To add reflex, simply adjust the aileron

clevises until each surface has approximately 2-3mm of ‘up’ (when measured from the

neutral trailing edge of the wing) just as shown below.

2-3mm

Rudder Neutral

2-3mm up ‘reflex’