User Manual

Me-163 GENERAL TIPS:

* Correct CG is essential for a smooth take-off when using the dolly. If the CG

is too far forwards, the Me-163 will bounce up and down before leaping into the

air. If the CG is too far back, it will jump up into the air too soon. So please check!

* Make sure you have read the ‘dolly take-off’ and ‘Hand Launching’ guidelines

given

on the previous pages of this manual.

* For optimum flight performance and model longevity, it is highly recommend that

you always fly with a balanced prop. The supplied prop should be balanced, but it

is always good to check first.

* 3S Flight packs of 30C discharge rate or above are recommended for use in the

Me-163 to ensure optimal flight and power system performance.

*Keep all leads within the fuselage area as tidy as possible. Tidy wires look better,

allow for easier access to all internal components, better battery installation,

increased airflow around electronics and a reduction in potential electronic signal

interference (noise).

*. Inspect the propeller frequently, especially if you have suffered a hard landing or

the prop has been knocked. If the prop is in any way damaged it must be replaced

and any loose fixings must be tightened.

Thank you again for purchasing the Durafly Me-163. We hope you’ll

have many happy days of flying and look forward to bringing you

more Durafly models in the future.

Don’t forget, spare parts are available for this model, please see the

next page for details.