User Manual

Problem Cause Solution
Motor does
not turn
1. Battery is not fully charged.
2. Transmitter battery low.
3. Motors not connected.
4. The motor is damaged.
5. Reciever is not bound to Tx.
6. ESC in set-up mode.
Control surfaces
not moving with
stick input
Model does not
fly straight
1. Control surfaces not centered.
2. CoG is not in the correct position.
Model does not
climb
1. The battery is not fully charged.
2. Elevator servo is reversed.
3. CG too far backwards.
Limited Radio
Range
1. Transmitter/ Receiver batteries
are flat.
1. charge/replace batteries.
Model moves
backwards
1. Turn the prop around .
2. Install a full charged battery.
3. Check for connection
between the ESC and
motor.
4. Replace motor.
5. Consult Radio manual and
go through bind procedure
again.
6. Hold model and move
throttle to full postion then
back down to idle.
1. Prop installed backwards
1. The servo lead is connected
to Rx incorrectly.
2. The servo is damaged.
1. Make sure the servo leads
are connect properly.
2. Replace servo.
1. Adjust the trims on the
transmitter.
2. Re-possition lipo as
suggested.
1. Charge the battery.
2. Change servo direction
via Tx.
3. Move battery forwards.
1.Charge the batteries.
TROUBLE SHOOTING:
2. Motor direction reversed
2. Disconnect any two motor
wires from ESC, swap
around and reconnect.
19