User Manual

2. Locate the bag marked ‘Aileron’ and install aileron control horns and rods for

each side of the wing as shown. Ensure the servo horn is at 90 degrees to the

wing when installing the control rod and connect to the outer hole on the servo

arm. Click each clevis shut on the horn once the rod is installed.

ASSEMBLY:

1. Out of the box your Me-163 comes with reinforced foam hinges. However before

assembly can begin, each hinge line must be flexed back and forth 6-8 times to

reduce tension, and load on the servo. Do this for all control surfaces before

continuing.

PB1.7X10mm