Goblin Racer Instruction Manual

9
Carefully position the fin/rudder assembly onto the seat on top of the tailplane making sure
the tongue on the rudder engages properly in the rear of the fuselage. Ensure the assembly
remains perfectly aligned with the fuselage as the glue sets.
Install the receiver of your choice, minimum of 4 channels.
Important Note: As the Goblin is quite a fast model we recommend that the EPO hinges of the ailerons and
elevator are reinforced with a good quality hinge tape such as 3M Blenderm tape. With the control surface
fully deflected down apply the tape to the top surface and ensure it is firmly pushed down into the gap. Turn
over and repeat this process on the underside of the control surface.