Goblin Racer Instruction Manual

1
Introduction:
This great looking little racer can trace it's lineage back to the very popular Rare Bear parkflyer racer. This
was a very fast parkflyer based on the Reno Racers that was amazing fun to fly, was very tough and it
became a firm favorite extremely quickly.
The Goblin carries on all these traits coupled with great looks and attention to detail. It comes with a choice
of 2 eye-catching color schemes either yellow/black/silver or pink/blue/black and factory applied decals. It
has scale looking ribbed control surfaces with dummy trim tabs on ailerons and elevator, racy looking
teardrop blisters on the cowling and streamlined painted canopy. A huge spinner that flows into the
cowling profile finishes of that streamlined racy look. The Goblin looks good on the ground but even better
in the air with it's tapered wing and rounded wing tips and tail feathers.
Power is provided by a powerful pre-installed 3536-1400KV brushless motor turning a 7 x 6 2 blade prop,
this is coupled to a high quality 45 amp Aerostar ESC. 3 x 9g servos with pushrods and control horns are also
pre-installed which makes for a very quick assembly time. The wide bodied fuselage not only looks good
but allows plenty of room and access for a 1000-1800mAh 4S battery. This combination of a lightweight
EPO airframe, a high power brushless motor and simple aileron and elevator set up puts the Goblin
amongst the most exhilarating park flyers on the market today.
So why not get a bunch of your flying mates to also purchase a Goblin, set up some pylons and do a bit of
inexpensive pylon racing, it's great fun. There is no need to modify the Goblin and large individual race
numbers are supplied to tell who is who. It is fast and great fun to fly as it comes out of the box which will
keep the racing more evenly matched for more exciting finishes. To make things even more exciting why
not design your own FPV platform and have great fun FPV racing with the Goblin.
We hope you enjoy assembling and flying your Goblin Racer as much as we enjoyed developing and testing
it.
Features:
• Quick assembly, can be ready to fly in 20 minutes
• Wide bodied fuselage for easy battery access
• 2 high visiblity color schemes available
• Large individual race numbers included
• Powerful 3536-1400KV brushless motor and 45A ESC pre-installed
• 3 x 9g servos with pushrods pre-installed
• One piece model for easy transportation
Specs:
Format: Plug and Play
Wingspan: 820mm (32.25ins)
Length: 615mm (24.25ins)
AUW (Ready to Fly): 820g (this will vary with battery choice)
Motor: 3536-1400KV brushless
ESC: Aerostar 45 amp
Propeller: 7 x 6 (2 blade)
Servos: 3 x 9g
Required:
4ch or greater transmitter and receiver
1000-1800mAh 4S lipoly battery (max weight 170g)