Goblin Racer Instruction Manual

4
Assembly:
The Goblin is a one piece model so the wing is permanently attached to the fuselage. If your
model has any residue paint on the surfaces to be glued then either lightly sand or prick the
surfaces with a pin to help the adhesion.
Apply a good foam adhesive or slow setting CA to the wing and fuselage surfaces
where they are to be joined.
Warning: Before you start to assemble the Goblin please read through
this manual as there are some important notes and updates you need to
be aware of before you start.
Before you glue the wing permanently to the fuselage please check the
operation of the ESC.