Instruction Manual

2.3x6mm

1. Out of the box your Excalibur comes with reinforced foam hinges. However before assembly can

begin, each hinge line must be flexed back and forth 5-6 times to reduce tension and load on the

servo. Do this for all control surfaces before continuing.

Test and center each tail servo then carefully install each tail half into the the housing at the

rear of the fuselage. Connect the servos to the extension leads and ensure they are pushed

forward into the fuselage when fitting the tail, for the perfect fit as shown (A). With the tail now

correctly in place, add the top tail mounting plate and secure using the supplied 2.3x6mm screws

(B). Turn the tail over and repeat this process (C). Finally locate and install the tail servo horns and

control rods (D).

Note:

- For max strength and security, UHU glue can be used in addition to supplied screws when installing the tail.

- When connecting ball links, the side with the ring molded on, is the side pressed onto the ball.

- Use of heat shrink or sticky tape is recommended to keep the extension/servo lead connection secure.

‘Pro’ propeller. 13 x 8 Full carbon

folder SKU: 445000071-0