Instruction Manual

3x20mm

2.3x6mm

Note:

- For increased performance, we suggest the optional 13x8 ‘Pro’ propeller blades. See page 2/3

-The propellers should be balanced out of the box, however it is recommended a final balance check be carried

out before attaching to the model. A well balanced prop will greatly increase all round performance and

efficiency of the model in flight.

Maintaining their aligned position, slide one wing panel onto the spars and into place on the

fuselage. Handle with care, as you may need a good firm push to get the wing fully into position.

Repeat with the remaining panel (A). With both panels firmly in place, secure with four of the

2.3x6mm screws as shown (B).

Bolt each prop blade to the hub using the supplied 3x20mm bolts and lock nuts. Do not over

tighten these bolts, the blade should be able to freely fold back (A). Now secure the prop and hub

onto the prop adapter and tighten the entire assembly onto the motor shaft and finish off by

screwing the spinner in place with the final 2.3x6mm screws (B).

The final stage of assembly is to install your choice of 4-6ch receiver, the smaller the better. With

all servo leads connected, the receiver can be inserted under the wing leading edge and secured

with if desired. Your 1800-2200mah 4S lipo (2200mah 4S ASPEC G2 shown) installs as seen below.

This is also the desired location for correct CG.