Manual

6
1. Before getting started, bind your receiver to your transmitter. Please refers to your
Transmitter Manual for the operation procedures. Make sure all the control sticks are
in neutral position(Rudder, elevator andailerons) and the throttle in the OFF position.
Turn on the transmitter make sure all the trims and the sub trims (For computerized
TX) are in neutral position, and then power on the ESC for the control system testing.
For safety reasons, it’s advised that this is done with the propeller removed.
2. Check all control surfaces are moving in the correct direction with the correct
stick input(see below).
SETTING UP YOUR MODEL:
Aileron Elevator Rudder