User Manual

ASSEMBLE THE MODEL

The Micro Tundra continues the lineage of the Tundra and Grand Tundra series of Durafly aircraft.

It is available in 2 color schemes, either the "Classic Green" or the slightly more outrageous and

colorful "Graffiti". Both look good and can be flown with either a standard wheel U/C or with floats

and water rudder, both versions are supplied in the box. Its small size makes it perfect for "Back

Yard Bush" flying.

The Micro Tundra comes in the usual Durafy Plug N Fly format so it has the motor, ESC and 6 micro

servo's preinstalled, these also include pre-fitted pushrods. You will require a 5/6ch micro receiver

with Molex 1.25 connectors or a 5/6ch micro receiver with standard JR type connectors and then

use adapters (see recommended items at the end of the manual). The Micro Tundra has working

flaps which are unusual for such a small model, they are really helpful and great fun for landing in

tight places. The large main wheels finish off the Tundra look and enable it to easily take off and

land on most surfaces. Swap the wheels for the supplied floats and the tailwheel for the water

rudder and ponds, streams and other small waterways become your playground.

Assembly is very straightforward so you will be flying very soon after opening the box. All of us at

Durafly hope you enjoy the assembly and the flying of your Micro Tundra.

Before you start the assembly we recommend

that you remove some of the plastic from the

former at the front of the servo/receiver bay. By

doing this it allows more room for access and it

does not remove any strength from the model.

Mark the former using a felt tip or pencil at the

points as shown in the image on the left.