User Manual

4
Use a sharp modelling knife to carefully cut
through the plastic. Ensure you leave a
slight notch at the top as shown so that the
locator on the front of the wing cannot move
side to side when the wing is in position.
1
Plug the servo and ESC connectors into the
receiver, be careful to plug the connectors
in correctly. Secure the receiver to the
inside of fuselage with either hook and loop
or double-sided tape. Insert the front wing
locator into the notch in the plastic former
and use the supplied self-tapping screw to
attach the wing. A small amount of contact
glue can be used between the fuselage and
the wing for extra strength and security.
Install the wing struts using the self-tapping
screws provided to secure the struts to the
fuselage and the wing. Make sure the
longer plastic connector is attached to the
wing and the shorter one attached to the
fuselage.
2