User Manual

SUGGESTED CONTROL THROWS:
7
_
_
_
Flaps
Half 40 degrees
These are a good place to start for initial flights, once you have flown the Micro Tundra a few
times you can adjust as necessary to suit your own flying style.
Control throws:
*Elevator 'low rates' 8mm 'high rates' 10-12mm in either direction from neutral.
*Rudder 'low rates' 6mm 'high rates' 10-15mm in either direction from neutral.
*Aileron 'low rates' 6mm 'high rates' 8-10mm in either direction from neutral.
Flaps on the Micro Tundra should be set for 3 stages (up/no flap, mid flap and full flap).
Either via your radio or mechanically by adjusting the length of the flap control rod (or via
both in most cases). Set mid flap to approximately 30°degrees and full flaps to
approximately 70° degrees to the wing, ensure that both flaps deploy equally at every stage.
If your radio has the ability to do this we recommend mixing some down elevator in when
you select full flap, about 3-4mm works very well with 70° of flap.
Note: When setting the ailerons set them 1mm up from neutral to create a slight reflex.
This improves the slow flight characteristics by reducing any tip stalling tendencies.