Instructions / Assembly

ManualsBrandsDuraHeat ManualsHeating, Ventilation, and Air Conditioning23,000 BTU Kerosene Portable Heater

CAUTION: "RISK OF BURNS"

DO NOT OPERATE HEATER WITHOUT INSTALLING THE PROTECTIVE GUARD OR GRILL.

1. REMOVE THE HEATER AND ALL PACKING MATERIALS FROM THE BOX. (Fig.2)

NOTE :

Save the shipping carton and packing

materials for future storage.

UNPACKING AND ASSEMBLY

Heater.

Top guard.

Handle.

Top plate

2 “C” cell batteries.

Siphon pump.

Bag of screws for top grill assembly.

Owner's manual.

Safety Tips Manual.

2. ASSEMBLING.

A) Remove all packing materials from heater:

(Fig.3)

B) MOUNTING TOP PLATE: (Fig.4)

Align the arrow marking on the top plate with the carrying

handle hole on the cabinet and place the top plate on the

cabinet.

C) INSTALLING FRONT AND REAR GUARDS:

(Fig.5A and Fig.5B)

Hang the upper portion of the front guard (notched to

allow for the igniter door) on the Upper Grill brackets with

the downward hooked grill rods. (Fig.5A)

Snap the lower portion of the front guard into the holes in

the Lower Grill brackets with the inward hooked grill

rods. (Fig.5B)

Install the rear guard in the same way.

Top plate

Carrying handle

Top guard

Batteries

Rear guard

Front guard

Siphon Pump

Top guard Screws

Fig.2

Fig.4Fig.3

Fig.5B

Fig.5A

arrow marking

carrying handle hole

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING

Summary of content (8 pages)

PAGE 1
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! UNPACKING AND ASSEMBLY CAUTION: "RISK OF BURNS" DO NOT OPERATE HEATER WITHOUT INSTALLING THE PROTECTIVE GUARD OR GRILL. 1. REMOVE THE HEATER AND ALL PACKING MATERIALS FROM THE BOX. (Fig.2) NOTE : Save the shipping carton and packing materials for future storage. Top plate Carrying handle Top guard Heater. Top guard. Front guard Handle. Rear guard Batteries Top plate 2 “C” cell batteries. Siphon Pump Siphon pump.
PAGE 2
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! D) INSTALLING CARRYING HANDLE: (Fig.6) Insert the carrying handle into the holes on the cabinet by aligning holes on brackets of top plate. E) INSTALLING TOP GUARD: (Fig.7) Align the 2 brackets on the top guard with the 2 mounting brackets on the front and rear guards. Secure each bracket with a screw. Make sure that the brackets on the top guard are positioned outside the mounting brackets on the front and rear guards. F) INSTALLING BATTERIES: (Fig.
PAGE 3
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! It is normal for a kerosene heater to give off a slight odor upon start-up and shut-down. After 5-10 minutes of operation, the heater should have reached its normal operating temperature and any odor should be very slight. NEVER store kerosene in direct sunlight or near a source of heat. NEVER use kerosene that has been stored from one season to the next. Kerosene deteriorates over time. "OLD KEROSENE" WILL NOT BURN PROPERLY IN THIS HEATER.
PAGE 4
NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! AUTOMATIC IGNITION SYSTEM For safety and convenience, this heater features an automatic ignition system. 2 "C" cell batteries, included with the heater, provide the power for the igniter which lights the wick once it has been raised to its maximum height. To use the automatic ignition system: Make sure the batteries have been installed. Turn the wick adjuster knob clockwise until the wick has been raised to its maximum height. (Fig.
PAGE 5
3 DESEMPACAMIENTO Y MONTAJE ADVERTENCIA: "RIESGO DE QUEMADURAS." NO USE EL CALENTADOR SIN INSTALAR LA CERCA PROTECTORA (LA VERJA) 1. SAQUE EL CALENTADOR Y TODOS LOS MATERIALES DE EMBALAJE DE LA CAJA. (Ilu. 2) NOTA: Guarde el cartón del envío y los materiales de embalaje para el almacenamiento futuro.
PAGE 6
D) INSTALAR EL ASA PARA LLEVAR ASA: (Ilu. 6) Inserte el asa en los agujeros en el gabinete por alinear los agujeros en los puntales del plato de la cima. E) INSTALAR LA VERJA DE LA CIMA: (Ilu. 7) Alinee los 2 puntales de la verja de la cima con los 2 puntales de montar en las verjas delanteras y traseras. Afiance cada puntal con un tornillo. Asegúrese que se posicionan los puntales en la verja de la cima dentro de los puntales de monta en las verjas delanteras y traseras.
PAGE 7
Es normal para un calentador de querosén emitir un olor ligero al encender y apagar. Después de 5-10 minutos de funcionamiento, el calentador debe de haber alcanzado su temperatura de funcionar normal y cualquier olor debe ser muy poco. NUNCA guarde el querosén en luz del sol directa o cerca de una fuente de calor. NUNCA use querosén que se ha guardado de una estación del año a la próxima. El querosén se deteriora con el tiempo. "QUEROSÉN VIEJO" no QUEMARÁ CORRECTAMENTE EN ESTE CALENTADOR.
PAGE 8
6 SISTEMA DE IGNICION AUTOMATICO Para la seguridad y comodidad, este calentador ofrece un sistema de ignición automático, 2 pilas "C", incluidas con el calentador, mantienen el poder del mechero que enciende la mecha cuando ésta se ha subido a su altura máxima. Para usar el sistema de ignición automático: - Asegúrese que las pilas se han instalado. - Gire el ajustador de mecha en el sentido de las agujas del reloj hasta que la mecha se ha subido a su altura máxima. (Ilu.