Use and Care Manual

ManualsBrandsDuraHeat ManualsHeating, Ventilation, and Air Conditioning1,500-Wats 120-Volt Electric Forced Air Heater

~ 4 ~

“SAVE THESE INSTRUCTIONS”

OPERATING INSTRUCTIONS

Note: When using the heater for the first time, you may notice a slight emission of smoke. This is normal

and will stop after a short time. The heating element is made of steel and was coated with a layer of

protective oil during production.

1. Position the fan heater so that it stands on a firm level surface (When used as portable) and at a safe

distance from wet locations and flammable objects.

2. Connect the fan heater to the proper electrical power. See grounding instructions.

3. Press power button to ON Position.

4. Set the thermostat dial to the maximum temperature.

5. Once the room reaches the desired temperature, turn the thermostat dial back until heating element turns

off. The heater will cycle automatically around this present temperature. To increase temperature, turn the

thermostat knob clockwise. To lower temperature, turn the thermostat counterclockwise.

Setting

Function

Unit is off

Fan Runs – No Heat

Fan Runs – Full Power Heat

Electrical outlet wiring must comply with local building codes and other

applicable regulations to reduce the risk of fire, electrical shock and

injury to persons.

Do not use this appliance if any part of it has been underwater.

Immediately call a qualified service technician to inspect the appliance

and replace any part of the electrical system which has been under

water.

IMPORTANT: Read all instructions and warnings carefully before

installation and use. Failure to follow these instructions may result in a

possible electric shock, injury to persons, fire hazard and will void the

warranty

Summary of content (4 pages)

PAGE 1
“SAVE THESE INSTRUCTIONS” IMPORTANT: Read all instructions and warnings carefully before installation and use. Failure to follow these instructions may result in a possible electric shock, injury to persons, fire hazard and will void the warranty OPERATING INSTRUCTIONS Note: When using the heater for the first time, you may notice a slight emission of smoke. This is normal and will stop after a short time. The heating element is made of steel and was coated with a layer of protective oil during production.
PAGE 2
Grounding Instructions: Make sure the heater is switched OFF before plugging the heater into the outlet. Connect to properly grounded outlets only. Note: The power cord has a polarized plug (with one blade wider than the other) that will only fit in a polarized outlet one way. If it does not insert easily try reversing the plug. If it still does not fit contact your electrician to replace your outlet. DO NOT defeat the safety purpose of the polarized plug.
PAGE 3
“GUARDE ESTAS INSTRUCCIONES” IMPORTANTE: Lea todas las instrucciones y advertencias antes de su instalación y uso. El incumplimiento de estas instrucciones puede resultar en una posible descarga eléctrica, lesiones a personas, peligro de incendio y se anulará la garantía INSTRUCCIONES DE OPERACIÓN Nota: Cuando se utiliza el calentador por primera vez, es posible que note una ligera emisión de humo. Esto es normal y se detendrá después de un corto período de tiempo.
PAGE 4
Puesta a tierra Instrucciones: segúrese de que el calentador se apaga antes de conectar el calentador en la salida. Conexión a tierra adecuada. Nota: El cable de alimentación tiene unenchufe polarizado (con una hoja más ancha que la otra) que sólo se podrá instalaren la toma polarizada una forma. Si no fácilmente intente invertir el enchufe.Si aun así no entra contacto con unelectricista para que sustituya la toma de corriente. No anule el propósito de seguridad del enchufe polarizado.