Safer Choice Standard

Ingredient
Original IDLH
Revised IDLH
Ingredient
Occupational Exposure Band Rating
Occupational Exposure Band Limit
Notes:
Occupational exposure banding is a process of assigning chemicals into specific categories or bands based on a chemical's potency and the
adverse health outcomes associated with exposure. The output of this process is an occupational exposure band (OEB), which corresponds to a
range of exposure concentrations that are expected to protect worker health.
zirconium 2-ethylhexanoate
25 mg/m3
Not Available
methyl ethyl ketoxime
Not Available
Not Available
carbon black
1,750 mg/m3
Not Available
Occupational Exposure Banding
methyl ethyl ketoxime
D
> 0.1 to ≤ 1 ppm
Exposure controls
Appropriate engineering
controls
Engineering controls are used to remove a hazard or place a barrier between the worker and the hazard. Well-designed engineering controls can
be highly effective in protecting workers and will typically be independent of worker interactions to provide this high level of protection.
Personal protection
Eye and face protection
Safety glasses with side shields.
Chemical goggles.
Skin protection
See Hand protection below
Hands/feet protection
Wear chemical protective gloves, e.g. PVC.
Wear safety footwear or safety gumboots, e.g. Rubber
NOTE:
The material may produce skin sensitisation in predisposed individuals. Care must be taken, when removing gloves and other protective
equipment, to avoid all possible skin contact.
The selection of suitable gloves does not only depend on the material, but also on further marks of quality which vary from manufacturer to
manufacturer. Where the chemical is a preparation of several substances, the resistance of the glove material can not be calculated in advance
and has therefore to be checked prior to the application.
Body protection
See Other protection below
Other protection
Employees working with confirmed human carcinogens should be provided with, and be required to wear, clean, full body protective clothing
(smocks, coveralls, or long-sleeved shirt and pants), shoe covers and gloves prior to entering the regulated area. [AS/NZS ISO 6529:2006 or
national equivalent]
Employees engaged in handling operations involving carcinogens should be provided with, and required to wear and use half-face filter-type
respirators with filters for dusts, mists and fumes, or air purifying canisters or cartridges.
Prior to each exit from an area containing confirmed human carcinogens, employees should be required to remove and leave protective
clothing and equipment at the point of exit and at the last exit of the day, to place used clothing and equipment in impervious containers at
the point of exit for purposes of decontamination or disposal. The contents of such impervious containers must be identified with suitable
labels.
Overalls.
PVC Apron.
Some plastic personal protective equipment (PPE) (e.g. gloves, aprons, overshoes) are not recommended as they may produce static
electricity.
For large scale or continuous use wear tight-weave non-static clothing (no metallic fasteners, cuffs or pockets).
Respiratory protection
Type A Filter of sufficient capacity. (AS/NZS 1716 & 1715, EN 143:2000 & 149:2001, ANSI Z88 or national equivalent)
Cartridge respirators should never be used for emergency ingress or in areas of unknown vapour concentrations or oxygen content.
The wearer must be warned to leave the contaminated area immediately on detecting any odours through the respirator. The odour may indicate that the mask is not functioning
properly, that the vapour concentration is too high, or that the mask is not properly fitted. Because of these limitations, only restricted use of cartridge respirators is considered
appropriate.
Cartridge performance is affected by humidity. Cartridges should be changed after 2 hr of continuous use unless it is determined that the humidity is less than 75%, in which case,
cartridges can be used for 4 hr. Used cartridges should be discarded daily, regardless of the length of time used
SECTION 9 Physical and chemical properties
Information on basic physical and chemical properties
Appearance
Not Available
Physical state
Liquid
Relative density (Water = 1)
Not Available
Odour
Not Available
Partition coefficient n-octanol
/ water
Not Available
Odour threshold
Not Available
Auto-ignition temperature (°C)
Not Available
pH (as supplied)
Not Available
Decomposition temperature
Not Available
Melting point / freezing point
(°C)
Not Available
Viscosity (cSt)
Not Available
Version No:
1.1
Page
6
of
15
Duralux Marine Enamel CAMO Duckboat Drab - M691
Issue Date:
10/13/2021
Print Date:
10/19/2021
Continued...