Use and Care Manual

1. Slide the door column (CDRA) into the base
U-channel
(B1RH) on the right side of the door.
Line up the pre drilled holes on column (CDRA)
with base ‘U’ channel. Secure with two (S1) screws
from inside. See fig.
Front
CDRA
B1RH
1
2&3
S1
Fig.3
B1RH
CDRA
Always place panels into frame at an angle
on top and slide in sideways and
downward for easy insertion.
Note
Make sure panels are right side up with
panel shingles facing down. Check the
stamped label on top of all panels.
FSPH
2. Insert the front side panel (FSPH ) into the
groove of column
(CDRA). Start at the bottom of
the panel at an angle then push into place.
Note
FSPH
CDRA
B1RH
FSPH
CDRA
1
Fig.1
Fig.1
CDRA
Fig.2
CDRA
B1RH
7