Use and Care Manual

8
8. Place the sliding channel assembly (SLAP & SRAP)
on the top of front column fitting at the both ends.
Secure with (S1) screws.
9. Insert 4 nos of top slider (TS) into the sliding channel
as per the direction shown.
10. Place the wall panel (WP3A) on the base bar
(BS2AP) front right side of the shed. Line up the
holes with base bar.
Secure with (S1) screws with washers from out side.
IMPORTANT: USE HAND GLOVES TO PREVENT INJURY.
SLAP
SRAP
FCFP
S1
SRAP
TS
WP3A
S1
FRONT
First fix the middle screws then
go to the edges.
Tip
BS2AP