Use and Care Manual

Fig.1
15
29. Fix the Column Support (CS) to the columns with
two (S1) screws at both corners.
30 Place the wall panel (WP3A) on the base bar
side (BS2AP) at back left. Line up the hole with
base bar and secure with (S1) screws with washers
from out side.
31. Place the wall panel (WP4A) on the base bar
back left (BLAP). Line up the holes with base bar
and secure with (S1) screws. See the blow up
Fig.1
Fig.2
IMPORTANT: USE HAND GLOVES TO PREVENT INJURY.
S1
COLP
COLP
CS
S1
S1 WP4A WP3A
FRONT
BACK
WP3A
WP4A
BLAP
Make sure the overlapping
position of panels is as
shown in fig. 2.
Note
First fix the middle screws then
go to the edges.
Tip
First fix the middle screws then
go to the edges.
Tip
BS2AP
BS2AP
2
1