Use and Care Manual

16
32. Place the wall panel (WP3A) on the base bar
(BS1AP). Line up the holes with base bar and secure
with (S1) screws with washer from out side.
33. Place the wall panel (WP4A) on the base bar
(BRAP). Line up the hole with base bar and secure
with (S1) screw with washer from out side.
34. Assemble the top back angle left & right (ABLAP
& ABRAP) together with (S7) screws.
See the blow up
Fig.1
Fig.1 Fig.2
DCL
BBF
IMPORTANT: USE HAND GLOVES TO PREVENT INJURY.
WP3A
S1
S1
BRAP
WP4A
BRAP
WP4A
ABRAP
ABLAP
S7
ABLAP
ABRAP
BSBP
WP3A
Make sure the overlapping
position of panels is as
shown in fig. 2.
Note
First fix the middle screws then
go to the edges.
Tip
First fix the middle screws (top
or bottom) then go to the edges.
Tip
BS1AP