Use and Care Manual

5
12. Place the entrance taper channel (ECAP) on
top of the (BBFP). Secure with (S1) screws to the
foundation. See fig. 1 & 2.
BBFP
BBFP
S1
Fig.1 Fig.2
ECAP
ECAP
BBFP
Parts Needed:
(2) Column short (COSP)
(16) Column long (COLP)
(4) Column support (CS)
(1) Wall panel front left (WP1A)
(1) Wall panel front right  (WP2A)
(4) Wall panel corner  (WP3A)
(9) Wall panel side  (WP4A)
(1) Sliding channel right (SRAP)
(1) Sliding channel left (SLAP)
(1) Sliding channel joint (SJP)
(2) Sliding channel cover  (SCAP)
(2) Top angle side front left / back right (AS1AP)
(2) Top angle side front right / back left (AS2AP)
(1) Top angle back left  (ABLAP)
(1) Top angle back right  (ABRAP)
(2) Center band front  (CB1P)
B. Walls & Columns
All panels are clearly marked
and care should be taken to
use the correct one.
Note
(2) Center band side front  (CB2P)
(2) Center band side back  (CB3P)
(9) Center band middle  (CB4P)
(1) Door column profile left (DCLP)
(1) Door column profile right (DCRP)
(4) Corner column fitting (CCFP)
(10) Center band fitting (CBFP)
(2) Door column bottom fitting (DCBF)
(2) Front column fitting (FCFP)
(18) Column fitting (CFP)
(4) Top slider (TS)
(158) Plastic washer (PW)
(7) Ventilation Blocking Cover front/back (VBCF)
(292) Sheet metal screw (S1)
(18) Sheet metal screw (S7)
IMPORTANT: USE HAND GLOVES TO PREVENT INJURY.
1. Place the corner column fitting (CCFP) on top of
the base bar (BBFP & BS1AP). Secure with the
three (S1) screws to the base bar.
Follow the same at the other corner.
CCFP
BBFP
BACK
BBFP
CCFP
S1
BBFP
BBFP
BS1AP
BS2AP
BS2AP
BS1AP
BS2AP
BS1AP
After completing the assembly
of the base bar fill the concrete
or sand upto the foundation
top suraface
Note