Installation Guide

ManualsBrandsDuramax Building Products ManualsKitchenCapistrano 80 in. x 55 in. Vinyl Lattice Arbor

Check Box for these Contents

Description Pcs.

Post

Roof Rails

Side Rails

3.1

Side Rails

3.2

Side Rails

Side Pickets

Lattice

Rafters

Post Pyramid Caps

7 Rafter Sharp Caps 12

Screws Pan Head 93mm

Screws Pan Head 55mm

10 Snap Cap w/ Washer 32

11 Vinyl Glue 1

12 Metal Ground Anchor 4

Capistrano Arbor

Footing with Concrete



Insert the 2 x 3½¨ metal ground anchors into the bottom

of the arbor post and secure with screws through the

predrilled holes. (Figure 4.1)

STEP 4: Arbor Footing Installation

If you have a problem or question

Please call 1 800 483 4674

(Mon-Fri • 8:AM to 4:PM PST)

or visit www.duramaxBP.com

Tools Required for Assembly

• Cordless Drill • Tape Measure

• Rubber Mallet • Level

• Stool or Ladder • Screw Driver



Move the arbor to its ﬁnal location (2 people will be needed). Set the

Arbor and mark the positions of the posts, then move the arbor aside

and lay it carefully on it’s side. Dig four holes approximately 6" wide x

18" deep. (Figure 4.2b)



Now move the arbor back into position. Support the arbor plumb and

level over the holes using blocks of wood, bricks, or stones under the

bottom rail of the side panel. (Figure 4.2b)



Fill the holes with wet cement within 3” of your grade (2 bags of Pre-

Mix Concrete-Sold Seperately). The vinyl post bottoms should insert

themselves approximately 1" into the concrete. (Figure 4.2b)

Thank You For Your Purchase

Arbor Assembly Instructions

Please Read Through Before Starting Assembly

General Information

• When assembling components, place on a non-abrasive surface to avoid scratching.

• While assembling the components do not use excessive force otherwise the components can be damaged.

Figure 4.1

Metal Ground Anchor

Figure 4.2b

6x18” deep hole

Blocks of wood,

bricks, or stones

Pre-Mix Concrete

Front View Side View

Summary of content (2 pages)

PAGE 1
STEP 4: Arbor Footing Installation Capistrano Arbor Footing with Concrete  Insert the 2 x 3½¨ metal ground anchors into the bottom of the arbor post and secure with screws through the predrilled holes. (Figure 4.1)  Move the arbor to its final location (2 people will be needed). Set the Arbor and mark the positions of the posts, then move the arbor aside and lay it carefully on it’s side. Dig four holes approximately 6" wide x 18" deep. (Figure 4.
PAGE 2
STEP 1: Assemble the Cover  Slide the Rafters through the holes in the Roof Rails in the sequence as shown below. (Figure 1.1)  Ensure a proper fit as shown in Figure 2.3. STEP 4: Arbor Footing Instructions  Push Side Panel Post untill the spacing appears even between the inside of Post & the first Rafter with remaining Rafters. (Figure 3.2)  Final adjustment to allow for a 40.5” opening between Posts (minor variation is allowed).