Wall Mount Unit Installation Manual

DURASTAR.COM12

INDOOR UNIT INSTALLATION

STEP 1: SELECT INSTALLATION LOCATION

Before installing the indoor unit, you must choose an appropriate location. The following

standards must be met for an appropriate location for the unit:

• Good air circulation

• Convenient drainage

• Noise from the unit will not disturb other people

• Firm and solid - the location will not vibrate

• Strong enough to support the weight of the unit

• A location at least three feet (one meter) from all other electrical devices (e.g., TV, radio,

computer)

DO NOT install unit in the following locations:

• Near any source of heat, steam, or combustible gas

• Near ﬂammable items such as curtains or clothing

• Near any obstacle that might block air circulation

• Near a doorway

• In a location subject to direct sunlight

Refer to the following diagram to ensure proper distance from walls and ceiling:

4 3/4” (12cm)

or more

6’ (1.83m) or more

4 3/4” (12cm)

or more

6” (15cm) or more

NOTE

If there is no pre-existing refrigerant piping, when choosing a location, leave ample room

for a wall hole (see Step 3: Drill Wall Hole for Connective Piping) for the signal cable and

refrigerant piping that connect the indoor and outdoor units. The default position for

all piping is the right side of the indoor unit (while facing the unit). However, the unit can

accommodate piping to either the left or right.