Owners Manual

DURASTAR.COM
15
MANUAL OPERATION (USE WITHOUT REMOTE)
The manual override button is intended for testing purposes and emergency operation. Please do
not use this button unless the remote control is lost and it is absolutely necessary. The unit must
be turned off before manual operation.
To operate your unit manually:
1. Open the front panel of the indoor unit.
2. Locate the MANUAL CONTROL button on the right-hand side of the unit.
3. Press the MANUAL CONTROL button one time to activate FORCED AUTO mode.
4. Press the MANUAL CONTROL button again to activate FORCED COOLING mode.
5. Press the MANUAL CONTROL button a third time to turn the unit off.
6. Close the front panel.
Manual control button
LED DISPLAY INDICATORS
The following is a list of possible indicators that may appear on the indoor unit's display. Not all
the display indicators may be available on the unit purchased.
Feature Indicator Notes
TIMER ON,
SWING, TURBO,
SILENCE
ON Displays for 3 seconds when the TIMER ON feature is set or the
SWING, TURBO, or SILENCE feature is turned on. If the unit is off,
ON will continue to be shown if the TIMER ON feature is set.
TIMER OFF,
SWING, TURBO,
SILENCE
OF Displays for 3 seconds when the TIMER OFF feature is set or the
SWING, TURBO, or SILENCE feature is turned off.
SELF CLEAN SC Displays when the SELF CLEANING feature is on.
FP FP Displays when the FP feature is on.
FORCED
COOLING
FC Displays when the FORCED COOLING mode is selected with the
manual control button. See Manual Operation section.
ANTI-COLD AIR
FLOW
cF The unit is designed not to blow cold air in HEAT mode. When
HEAT mode is selected the unit will display "cF" until the set
temperature is reached and the unit can blow warm air.
DEFROST dF Displays when unit is defrosting. This may last 5-10 minutes
depending on the outdoor temperature and the amount of frost
buildup on the outside unit.