Wall Mount Installation Manual

DURASTAR.COM
13
STEP 3: DRILL WALL HOLE FOR CONNECTIVE PIPING
1. Determine the location of the wall hole based on your unit's mounting plate dimensions. Use the
installation template provided with the indoor unit to correctly position the wall hole, or refer to
the illustration below.
STEP 2: ATTACH MOUNTING PLATE TO WALL
1. Remove the screw that attaches the mounting plate to the back of the indoor unit. The mounting
plate is the bracket on which you will mount the indoor unit.
Screw
Correct orientation of mounting plate
9” (228mm)
9” (229mm)
15 13/16” (401mm)
5” (127mm)
1 5/8” (42mm)
11 11/16” (297mm)
Left rear wall
hole 2 1/2” (64mm)
Right rear wall
hole 2 1/2” (64mm)
Indoor unit outline
31 9/16” (802mm)
2 1/4” (58mm)
1 7/8” (47mm)
Model 9K and 12K
8 11/16” (221mm)
22 3/4” (578mm)
11 3/4” (298mm)
13 3/16” (336mm)
Left rear wall
hole 2 1/2” (64mm)
Right rear wall
hole 2 1/2” (64mm)
Model 18K and 24K
42 1/2” (1080mm)
2 1/8” (54mm)
1 15/16” (49mm)
3 1/8” (79mm)
2 1/8” (54mm)
1 15/16” (49mm)
(149mm)
5 7/8”
5 7/8” (149mm)
5 7/16” (138mm)
Indoor unit outline
2. Secure the mounting plate to the wall with the anchors and screws provided. Make sure that
mounting plate is flat against the wall, and is level.