Installation
15
appropriate length (or lengths) of Chimney
Section(s) above the Elbow. Attach the
second Elbow above the Chimney Section to
complete the offset (Fig. 17).
Use an Elbow Strap to
secure the offset. Secure the Elbow Strap’s
band to chimney around the upper portion of
the top Elbow, then tighten the nut and bolt
until the clamp is rm. Wrap the Elbow Strap
end over an adjacent joist or rafter and secure
it with at least two 8-penny nails or #8, 1-1/2”
screws. Add additional Elbow Straps for each
section of chimney in the offset (Fig. 18).
Every chimney section in the offset must be
supported. Do not add more Chimney Sections
until the Elbows and the offset are supported.
Be sure that the chimney above the second
elbow remains vertical.
When wood is burned
slowly, it produces tar and other organic
vapors, which combine with expelled moisture
to produce creosote. The creosote vapors
condense in the relatively cool chimney ue
of a slow-burning re. As a result, creosote
residue accumulates on the ue lining. When
ignited, this creosote makes an extremely hot
re.
Chimneys must be installed so that
access is provided for inspection and cleaning.
The chimney should be
inspected at least once every month during the
heating season to determine if creosote or soot
has built up. Check spark arrestor screens
at least every 2 to 4 weeks. If creosote or
soot has accumulated on the spark arrestor, it
should be cleaned or replaced to reduce the
risk of chimney re.
Have your chimney cleaned
by a professional Certied Chimney Sweep
if you have doubts about your ability to clean
it. Use a plastic, wood, or steel brush. Do not
use a brush that will scratch the stainless steel
liner of your chimney. Scrub the spark arrestor
with a wire brush. To remove the Chimney
Cap for cleaning, unscrew the four screws that
attach the top lid of the Cap to the cap's legs.
To reduce corrosion in chimneys
where coal is burned, clean the chimney
thoroughly within 48 hours of shutting down
the appliance for the season.
Use chemical
cleaners only as a last resort, and use only
those that the manufacturer specically
warrants as being non-corrosive to the
chimney. DuraVent will assume no liability for
damage resulting from the use of chemical
cleaners.
If a ue re occurs,
close all possible air inlets, and call your Fire
Department. Do not use the chimney again
until it has been inspected by a Certied
Chimney Sweep for possible damage.
As an option, you can coat all
exterior metal parts, with the exception of the
top portion of the Chimney Cap, with high
temperature, rust proof paint. Wash the metal
with a vinegar and water solution to remove
any oil residue before painting. Painting the
chimney will help to increase chimney life.
DuraVent assumes
no liability for structural damage or roof
contamination as the result of creosote
formation. It is the owner’s responsibility
to comply with inspection and cleaning
requirements as described in these
instructions, and those of the appliance
manufacturer.